(2013) Use of Quarry Dust to replace of Sand in Concrete. Based on this experimental investigation it is found that quarry dust can be used as alternative material to the natural river sand. The physical and chemical properties of quarry dust satisfy the requirements of the aggregate. It is found that quarry dust improves
It is found that quarry dust improves the mechanical properties of concrete when used along with super plasticizers. In fact we need high strength concrete to withstand to the heavy loads in a …
The Chemical composition of FA and OPC by XRF is assigned in the following Table 2. Table 2. Chemical composition of FA and OPC by XRF. ... Fine aggregate properties of specific gravity, bulking of sand, fineness modulus, and grading zone. In quarry dust properties of density, water absorption, max operating temp, tensile strength, flexural ...
Cohen et al. (2019) studied the integration of dolomite-based quarry dust waste material as a partial replacement of cement and FA in cement-based (CEM) and FA-based geopolymer mortars, respectively [9]. The FA was replaced by quarry dust wastes at five different percentages, i.e., 0%, 10%, 20%, 30%, and 40% by weight of total geopolymeric binder.
This study proposes a novel approach by integrating geopolymerized bagasse ash (GBA) and geopolymerized quarry dust (GQD) along with shredded facemasks (FM) for the balanced amelioration of fat clay. Extensive geotechnical testing and mineralogical and microstructural analyses were conducted to assess the performance of the proposed multi …
Many studies investigated the effects of waste quarry dust incorporation as a replacement to ordinary Portland cement, with researchers, (e.g., Kartini et al., 2014;Rathore et al., 2020; Imran and ...
B. Geotechnical properties of quarry dust and mix Grain size analysis of crusher dust and soil mixed with different proportions of lime conducted as per IS: 2720 (part 4)-1985 in this study is specified in Fig. 2 and Fig. 3. The value of specific gravity determined for the quarry dust is found to be 2.67. Fig. 2. Gradation of quarry dust. Fig. 3.
The chemical composition of quarry dust and river sand is as follows The physical properties of river sand and quarry dust are concentrated on specific gravity, density, void ratio, unit weight and sieve analysis.
of quarry dust as the fine aggregate decreases the cost of concrete production in terms of the partial replacement for natural river sand. Design mix of M20 grade concrete with replacement of 5%, 10%, 15%, and 20% 0f quarry dust. Key Words: Quarry dust, Bagasse ash, Compressive strength, split tensile strength. 1. INTRODUCTION
The chemical compositions of ordinary Portland cement, periwinkle shell ash, and quarry dust used in concrete production are revealed in Table 1. Whereas the physical characteristics of the constituents are presented in Table 2, the sieve analysis of the aggregates was in line with and according to the limits specified by ASTM C90 ( 2017 ).
Typical values as obtained by Anya (2015) include: • Specific gravity – 2.74 • Bulk density – 1296 kg/m3 • Fineness modulus – 2.93 • Coefficient of uniformity, Cu – 6.84 • Coefficient of gradation, Cc – 0.65 2.2.2 Chemical properties of quarry dust The chemical constituents of quarry dust are as given in Table 2.2.
The major chemical constituents of quarry dust residues are listed in Table 4. Table 4 Chemical compositions of quarry dust. Full size table. The usage quarry rock residue those may be known as artificial sand has been well-known as a constructing product inside the industrially superior nations of the west over the last three a long time. The ...
Download Table | Typical chemical composition of quarry rock dust and natural sand from publication: Effect of replacement of natural sand by quarry dust and waste plastic on compressive & split ...
The chemical compositions of cement, quarry dust and river sand were determined by X-ray fluorescence and are summarized in Table 2. The combined composition of aluminum and iron (Al 2 O 3 + Fe 2 O 3) were 22.82 and 3.60% in quarry dust and river sand, respectively. Also, quarry dust had higher calcium and aluminum content compared to river sand.
... chemical composition of Quarry dust is shown in Table 3. From the results, Quarry dust is collected from local stone crushing units was usedpared with wood, however, bamboo has...
Fig. 1 Standard Proctor Curve of quarry dust . According to Fig. 1, the maximum dry unit weight of the quarry dust sample was 19.4 kN/m 3. 3.2 Determination of field dry unit weight in each trial • The total wet weight (W wet) of the quarry dust was measured before placing it into the con-tainer and the dry weight (dry) of the quarry W
Quarry dust can be used as a substitute for sand to improve the properties of lateritic soil Soosan et al. (2001b). Sridharan et al. (2005), conducted studies on the effect of quarry dust on the ...
Chemical analyses of dust were done to check on the toxicity of dust from the quarry, so as to predict its pos- sible impacts on human health and the environment.
Quarry dust with alkali basaltic origins was sourced from Silver Stone Quarry Limited in Machakos, Kenya. The quarry dust and PP pellets used are shown in Fig. 1a,and b, respectively. The chemical composition of the quarry dust, obtained using Bruker S1 TITAN XRF analyser, is presented in Table 1.
Geopolymer concrete, also known as an earth-friendly concrete, has been under continuous study due to its environmental benefits and a sustainable alternative to conventional concrete construction. The supplies of …
with vermiculite, quarry dust and steel slag in the proportions of 10%, 25%, 50%, 75% and . The best proportion of GGBFS in the fly ash bricks is also identified in this report. In this study the fly ash bricks are self cured by forming geo polymers. Index Terms – Fly ash bricks, GGBFS, vermiculite, quarry dust, steel slag, geo polymers. 1.
chemical properties, workability of the quarry dust concrete, with different ratios of 0%, 20%, 30%&40% for M20 grade of concrete behavior of quarry dust reinforced
Quarry dust which is a waste product from aggregate crushers could replace sand. Construction of pavements in expansive soils creates a lot of problems for civil engineers, stabilization with ...
The density of quarry dust can vary depending on the composition and moisture content, but on average it is typically around 1.5 - 1.6 grams per cubic centimeter. This answer is: 👍 Helpful ( 0 ...
different quarry dusts by studying the physical and chemical properties, workability of the quarry dust concrete, with different ratios of 0%, 20%, 30%&40% for M20 grade of concrete behavior of quarry dust reinforced cement concrete beams, Sieve analysis was conducted for quarry dust and sand. Mix design has been developed using
This work is focused on the use of quarry dust as a total replacement to river sand in the production of concrete, and comparing the results (compressive strength) to that obtained from conversional concrete made with river sand ... (Mass of chemical Admixture / Specific Gravity of chemical Admixture) X (1/1000) = (0.8 % 0f 370 / 1.1) X (1/1000 ...
This paper presents a study on the combined use of two by-products, namely quarry dust (QD) and ferronickel slag (FNS), as a full substitute for natural sand to improve the greenness of concrete production. Quarry dust was used in increments of 25% to a maximum of 75% substitution, where nickel slag was used as the remaining proportion of fine aggregate. …
The bulk generation of quarry dust (QD) from quarries, aggregates, and decorative stone plants, is a serious environmental issue. However, QD has the potential to provide eco-economic and technical merits when incorporated in the construction products. This review provides current investigations on the development of QD-based cementitious material.
Table 2 showing the typical chemical properties of quarry dust and natural sand [2] Constituents Quarry Dust (%) Natural Sand (%) Test method SiO2 62.48 80.78 IS 4032- 1968Na2O Al2O3 18.72 10.52 Fe2O3 6.54 1.75 CaO 4.83 3.21 MgO 2.56 0.77 Nil 1.37 K2O 3.18 1.23 TiO2 1.21 Nil Loss of ignition 0.48 0.37 C. Advantages of Quarry Dust:
The purpose of this research is to study the effects of quarry rock dust (QRD) and steel fibers (SF) inclusion on the fresh, mechanical, and microstructural properties of fly ash (FA) and ground granulated blast furnace …
The flexural strength of concrete was reported to increase by 14 and 21% when quarry dust and waste foundry sand were used at the mass proportion of 70:30 and 80:20, respectively. The quarry dust and waste foundry sand's mass proportion of 80:20 had been defined as the optimal combination ratio for best flexural strength performance.
III. QUARRY DUST A. Origin of Quarry Dust: The quarry dust is the by-product which is formed in the processing of the granite stones which broken downs into the coarse aggregates of …
Among these occurrences Jebel Alima (Redeyf region) is an open pit quarry. After extraction, raw phosphate requires several stages of treatments to become concentrated: crushing, grinding,...
7 10% 0f Quarry Dust Concrete of CC1:1.5:3 21.16 8 15% 0f Quarry Dust Concrete of CC1:1.5:3 21.41 9 20% 0f Quarry Dust Concrete of CC1:1.5:3 17.19 . International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395-0056
Concrete quarry dust blocks (CQDB) are manufactured from a mixture of cement: sand: quarry dust. A descriptive study using structured questionnaires and Laboratory test procedures was...